Note de ce sujet :
  • Moyenne : 0 (0 vote(s))
  • 1
  • 2
  • 3
  • 4
  • 5
KNX Kit - Problem in Detecting KNX interface
Thanks pollux6.

Well they are in the same segment. They were in 10.x.x.x network. I did that to make it in other segment than my wireless network. I worked your advice and configured my DHCP to assign addresses in the range 192.168.0.x. 224.x.x.x is the multicast and is shown there with no configuration from my side. It tests ok for the card or the called IP routing by ETS.

After I made changes to IP addresses it still not ok when tested by ETS although it shows the MAC address of the router and the status of the LED. There is something in configuration that I am missing but I do not know what it is!!

Once again thanks pollux6.

Messages dans ce sujet
RE: KNX Kit - Problem in Detecting KNX interface - par labkhan - 10/01/2016, 00:42:00

Atteindre :

Utilisateur(s) parcourant ce sujet : 1 visiteur(s)