I am using ETS 5 to connect by KNX bus with KNX USB interface but ETS 5 dont allow me to select USB interface it allows only IP tunneling interface. anyone support me about this topic.
Thanks
Thanks
ETS 5 Configured İnterface problem
|
I am using ETS 5 to connect by KNX bus with KNX USB interface but ETS 5 dont allow me to select USB interface it allows only IP tunneling interface. anyone support me about this topic.
Thanks
09/03/2015, 07:26:23
Hello,
Try to disconnect your IP interface, and only connect your usb interface, with the power and One device. Regards, Olivier
Intégrateur en solutions domotiques résidentielles, tertiaires et industrielles
|
« Sujet précédent | Sujet suivant »
|