+- Forum KNX francophone / English KNX forum (https://www.knx-fr.com)
+-- Forum : Français (https://www.knx-fr.com/forumdisplay.php?fid=3)
+--- Forum : ETS (https://www.knx-fr.com/forumdisplay.php?fid=9)
+--- Sujet : please press programming buttons but nothing happens!!! (/showthread.php?tid=4502)
please press programming buttons but nothing happens!!! - Hesamedin - 16/12/2016
Hello Friends,
I'm Sorry, I can't speak French.
I just had a question. I'm inside a project and I'm using Schneider Power supply with ABB IP Interface 3.1.1 and Yonnet Actuator with Schneider and ABB push button, after telling these details, I have explain my problem is in ETS5 and even ETS4. When I click on Download all and press the programming button on my devices, doesn't happen anything!
I tested IP interface and I can ping that and I set the backbone on IP and Line on TP and don't know where is my fault!!
Thank you for your answers.
And these are the images of ETS5
RE: please press programming buttons but nothing happens!!! - Jonathan007 - 20/12/2016
Hi, there is a special forum in English.
You have probably a problem on the bus... Check your bus cable.