Note de ce sujet :
  • Moyenne : 0 (0 vote(s))
  • 1
  • 2
  • 3
  • 4
  • 5
KNX Hardware not workng
#1
Hi Everybody,

Greetings!

I am new to KNX and has recently started some little work on KNX.
I have bought following items from Tapko Technologies GmbH

http://www.tapko.de/sim-knx.html
http://www.opternus.com/en/tapko/sim-knx.html

1. SIM-KNX Module
2. SIM-KNX-EVAL

I have connected SIM-KNX-EVAL to Serial Port of Desktop Computer and tried to send commands through the Test Application given by Tapko (developed in VC++). However, the SIM-KNX-EVAL is not responding (I have checked the serial port working and it is working well).

Also I am not getting any signal on KNX Bus. Please help me on how to resolve this issue.

a. Am I doing any mistake here?
b. Do I need to connect any External KNX Power Supply to make it working?
c. If Yes, can I use normal Regulated Power Supply?
d. Do it need to connect any KNX Enabled Device / Appliance?
e. How to make sure that the Device which I have bought are working perfectly?

Waiting for your suggestion.

Regards,

Dinesh
Répondre


Messages dans ce sujet
KNX Hardware not workng - par dinesh4761 - 28/07/2015, 14:29:53
RE: KNX Hardware not workng - par fma38 - 28/07/2015, 16:33:21
RE: KNX Hardware not workng - par Daisy11 - 05/03/2018, 12:23:25

Atteindre :


Utilisateur(s) parcourant ce sujet : 1 visiteur(s)